Sprayer module

Spraying

An alarm comes on after 3 s: pressure below the minimum while spraying, above the maximum, flow outside the tolerance, or flow with every section closed. AgOpenWeb shows it and sounds it.

Sections from AgOpenWeb

–

The section widths come from AgOpenWeb (Tool → Sections) and are kept here. They give the open width for the L/ha.

Sensors

No sensors: the module sends no sprayer readings (PGN 160 and 161), so AgOpenWeb and the AiO module page show none.

Sensor voltage

–

Flow

–

Flow pulses

–

Applied

–

Master switch

–

Bucket test: with one nozzle open, fill 10 L and note the litres counted. New pulses per litre = old × (counted ÷ 10).

AgOpenWeb

Program

–

Last section message

–

Last hello

–

Speed

–

Hydraulic lift

–

Tramline

–

Messages

–

Output polarity

–

Relays

What each relay does comes from the program (Tool → Machine → Pin config).

Module

Board

–

Name on the network

–

Up

–

Free memory

–

Own Wi-Fi network

–

Tractor network

–

Module IP

–

Signal

–

Program subnet

–

The program looks for the machine module at <subnet>.123 on the tractor network. The subnet comes from the program (PGN 201), or is set below.

Network settings

Own Wi-Fi network

Always on, at 192.168.4.1. Its password is also the one for changing the settings and the firmware.

Tractor Wi-Fi network

Program network

The module restarts to apply them: every section closes for a few seconds. If you change the name or the password of the own network, connect the phone to the new network again. Forgot the password? Hold the IO0 button 5 s, or in the serial monitor (USB): wifi-reset.

Events