Seeder module

Relays

What each relay does comes from the program (Tool → Machine → Pin config).

A seed drill with more than 16 sections needs the relays in a row from section 1: AgOpenWeb's pin config only knows sections 1-16, and sends sections 17-64 in PGN 229.

AgOpenWeb

Program

–

Last section message

–

Sections 17-64 (PGN 229)

–

Last hello

–

Speed

–

Hydraulic lift

–

Tramline

–

Messages

–

Output polarity

–

Module

Board

–

Name on the network

–

Up

–

Free memory

–

Own Wi-Fi network

–

Network cable

–

Tractor Wi-Fi

–

Module IP

–

Signal

–

Program subnet

–

The program looks for the machine module at <subnet>.123 on the tractor network. The subnet comes from the program (PGN 201), or is set below.

Network settings

Own Wi-Fi network

Always on, at 192.168.4.1. Its password is also the one for changing the settings and the firmware.

Tractor Wi-Fi network

Program network

The module restarts to apply them: every section closes for a few seconds. If you change the name or the password of the own network, connect the phone to the new network again. Forgot the password? In the serial monitor (USB): wifi-reset (or the BOOT button held 5 s, see the README).

Events